This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
todo:start [2015/05/11 03:57] vk6nk [20m roof antenna] |
todo:start [2015/07/12 05:38] vk6nk [20m roof antenna] |
||
---|---|---|---|
Line 5: | Line 5: | ||
[[:todo:antennas:20mroofvertical|Antenna Page]] | [[:todo:antennas:20mroofvertical|Antenna Page]] | ||
- | * Replace top sections with 2.7m stainless steel whip | + | * <del>Replace top sections with 2.7m stainless steel whip</del> |
- | * Double hose-clamp at top, single at bottom. | + | * <del>Double hose-clamp at top, single at bottom.</del> |
- | * Bonding wire | + | * <del>Bonding wire</del> |
- | * Tune | + | * <del>Tune</del> |
+ | * <del>Weather proof feed point</del> | ||
* Replace feeder with RG213 | * Replace feeder with RG213 | ||
* <del>Radio connection</del> | * <del>Radio connection</del> | ||
- | * Antenna connection | + | * <del>Antenna connection</del> |
* Install ATU | * Install ATU | ||
- | * LDG Z100Plus | + | * LDG AT7000 |
===== 10m roof antenna ===== | ===== 10m roof antenna ===== | ||
[[:todo:antennas:10mroofvertical|Antenna Page]] | [[:todo:antennas:10mroofvertical|Antenna Page]] | ||
+ | * Install balun | ||
* Install earth coil | * Install earth coil | ||
* Compare with 20m + ATU | * Compare with 20m + ATU | ||
* Possibly replace with stainless steel whip | * Possibly replace with stainless steel whip | ||
+ | |||
+ | ===== Misc antenna work ===== | ||
+ | |||
+ | * Connect new GPS antenna | ||
+ | * Re-locate microwave antenna | ||
+ | * Move weather station on TV antenna pole | ||
+ | * Move temp sensor to bottom of pole | ||
+ | * Re-use second TV antenna pole to brace 20m antenna | ||
===== IC-706MKIIG ===== | ===== IC-706MKIIG ===== | ||
Line 27: | Line 38: | ||
* <del>Invert PPT from RTS</del> | * <del>Invert PPT from RTS</del> | ||
* DC blocking cap on PC Mic port | * DC blocking cap on PC Mic port | ||
+ | * Mount for quick removal / reconnection | ||
===== X1M ===== | ===== X1M ===== | ||
* Rig [[:todo:antennas:portable20mvertical|portable 20m vertical]] using collapsible pole | * Rig [[:todo:antennas:portable20mvertical|portable 20m vertical]] using collapsible pole | ||
+ | * 9m squid-pole | ||
+ | * 5m squid-pole | ||
+ | * 5.6m tent pole | ||
* Test [[:todo:antennas:qrptuner|tuner]] with long wire | * Test [[:todo:antennas:qrptuner|tuner]] with long wire | ||
* AGC board | * AGC board | ||
Line 40: | Line 55: | ||
* Make double-adaptor anderson plug | * Make double-adaptor anderson plug | ||
* <del>Earth lead</del> | * <del>Earth lead</del> | ||
+ | * <del>Frequency alignment</del> | ||
+ | * External speaker | ||
+ | * Compare RX sensitivity to IC-706 using R2000 | ||
+ | * Audio connections for computer | ||
+ | * Possibly use Dad's RigBlaster | ||
* Install relay-replacement mod | * Install relay-replacement mod | ||
* Setup panadaptor port and connect RTL-SDR receiver | * Setup panadaptor port and connect RTL-SDR receiver | ||
* <del>Enable IF output through jumper settings</del> | * <del>Enable IF output through jumper settings</del> | ||
* Measure output voltage of IF | * Measure output voltage of IF | ||
+ | * Attempted with oscilloscope - no signal recorded | ||
+ | * Try again with R2000 as signal source | ||
* Build attenuator to match signal down to RTL level | * Build attenuator to match signal down to RTL level | ||
+ | |||
+ | ===== Car Radios ===== | ||
+ | |||
+ | * Install fuse block | ||
+ | * Mount speaker | ||
+ | * Fix speaker connections | ||
+ | * Hands-free | ||
+ | * Microphone | ||
+ | * Pre-amp | ||
+ | * PTT switch | ||
===== Study ===== | ===== Study ===== | ||
* Clean up! | * Clean up! | ||
- | * IKEA shelves next to desk for PC, PSU, Server, etc | + | * <del>IKEA shelves next to desk for PC, PSU, Server, etc</del> |
* Construct monitor stand and install radios | * Construct monitor stand and install radios | ||
* Bookshelf | * Bookshelf | ||
* Echo dampening (framed posters/shelves?) | * Echo dampening (framed posters/shelves?) | ||
* Install new network ports | * Install new network ports | ||
- | * Install new power points | + | * [[todo:OfficePower|Power Distribution]] |
- | * Improve DC distribution | + | * Install new power points |
+ | * Improve DC distribution | ||
* Relocate printers (stacking shelves?) | * Relocate printers (stacking shelves?) | ||
* Build speakers & amp | * Build speakers & amp |